HPCorse has come out with a solution for those individuals who are concerned about overheating their OEM turnsignals when they upgrade to a high mount SP-1 Exhaust for the Tenere 700. This is achieved by installing HPCorse's license plate along with Click'N'Ride's Universal Turn Signals.

Click'N'Ride Removable Motorcycle Turn Signals are universal LED turn blinkers for off-road and enduro dirt bikes, they utilize a click-release system which allows riders to quickly remove their turn signals when going off-road and protect them from being broken off. They are comprised of a simple, rugged construction - no moving parts to wear out and the rubber moisture guard protects the socket from mud, dust and water when the light is removed.

Lens combine unique frosted outer surface with concave, crystal bright inner zone featuring 3D cats-eye lens optics. Philips LEDs provide a high brightness, stable amber colour light source for up to 50,000 hours The UNIVERSAL socket can be installed on virtually any bike. CLICKnRIDE have been tested and certified (E-Mark) so are fully road legal.

HPC-YAT700PLATE Features

• Black stainless steel structure with fixed support that lasts in time and gives your Tenere a sporty look besides of offering and overall weight reduction to the rear tail (if compared to the original support).
• HP Corse’s unit is lighter and appealing - Designed to prevent overheating of the turn signal when installing SP-1 SHORT TITANIUM exhaust.
• Not compatible with OE indicators.
• Simply assembly through the bike’s pre-existing holes and housings. Necessary hardware supplied - no permanent changes are made to the bike.
• LED strip to enlighten the license plate included
• Designed to comply with the current EU road rules

Click 'N' Ride Features

• Micro-LED quick-release turn indicators
• Stylish design to compliment any motorcycle
• Universal fit
• Dirt and Moisture Guard
• Converts globed-bike to LED without changing the original Flasher Relay

Pack Includes

• 1 Quick Release Indicator (LEFT)
• 1 Quick Release Indicator (RIGHT)
• 2 Socket with Moisture Guard and Wiring (Bullet Ends)
• 2 Nylon Spacers (1mm)
• 2 Nylon Spacer (2mm)

Universal Socket Installation Notes

To ensure the socket is correctly installed on your bike, add/remove the included plastic spacers so the notch on the nut ends up flush with the top of the thread of the socket. If required, reduce the thickness of your bike’s plastics with hi-grit sandpaper or dremmel tool (work from the inside of the plastic). To complete socket installation align moisture guard, apply thread lock and screw nut on finger-tight. Insert the light into the socket and holding the light in the correct forward or rear facing position, hand-tighten the socket.

NOTE: OVER TIGHTENING THE NUT MAY DAMAGE THE SOCKET.

NOTE: HPCorse mufflers sold by TripleClamp Moto may or may not have the TripleClamp Moto engraved on the silencer.